HQ-Power HQLP10030 Manual Del Usuario página 6


This device should only be serviced by qualified service personnel.

Do not use the luminaire with a cracked or broken protective shield. Disconnect
immediately from the mains. The protective shield is not replaceable.

Familiarise yourself with the functions of the device before actually using it.

Always make sure to connect the device to an alternating current matching the
value stated on the device.

Always install the device in a well-ventilated location.

Keep this device away from dust and extreme temperatures. Make sure the
ventilation openings are clear at all times. For sufficient air circulation, leave at least
2.5 cm in front of the openings.

Never connect the device to a dimmer or rheostat.

Never carry or move the device from the power cord or any other moving part.
Always use the bracket.

In the event of an operating problem, stop using the device immediately.

Never try to repair the device. There are no user-serviceable parts inside the device.
Refer to an authorized dealer for service and/or spare parts.

This device is not designed for permanent operation: regular operation breaks will
prolong its live.
3. General Guidelines

Refer to the Velleman
manual.

All modifications of the device are forbidden for safety reasons. Damage caused by
user modifications to the device is not covered by the warranty.

Only use the device for its intended purpose. Using the device in an unauthorised
way will void the warranty.

Damage caused by disregard of certain guidelines in this manual is not covered by
the warranty and the dealer will not accept responsibility for any ensuing defects or
problems.

Nor Velleman nv nor its dealers can be held responsible for any damage
(extraordinary, incidental or indirect) – of any nature (financial, physical...) arising
from the possession, use or failure of this product.

Keep this manual for future reference.
4. Installation
4.1 General Guidelines

Have the device installed by a qualified person, respecting all applicable norms.

Install the device on an even, fire-resistant, scratch-resistant, water-resistant and
non-slippery surface.

The carrying construction must be able to support 10 times the weight of the device
for 1 hour without deforming.

Make sure there is no flammable material within a 1 m radius of the device.

Install the device in a location with few passers-by that is inaccessible to
unauthorised persons.

Install the device in a location where you can easily access the power cord.
V. 03 – 15/10/2018
HQLP10030
®
Service and Quality Warranty on the last pages of this
6 ©Velleman nv