Publicidad
Idiomas disponibles
Idiomas disponibles
6.4
Connection to the Power Supply
1. Make sure the on-off switch is in the off position.
2. Double the power cord, about 30 cm from the end and lead the loop through the hole on the safeguard.
3. Pull it over the cord retainer and gently tug on the cord to ensure that it is firmly secured.
4. Connect the power cord to a suitable socket.
7.
Operation
Make sure the device is connected to the mains. Squeeze the on-off switch to switch on the device; release to
switch off.
Line Feeding
During use, the trimming line will get shorter due to
wear. We recommend to regularly check its length
and adjust if necessary. The trimmer spool is
equipped with a bumper helping to feed the trimming
line while using the device. To adjust the line length,
just tap the bumper [11d] on solid ground and the
spool will release trimming line. Excess line will be
cut by the knife and should always remain inside the
radius of the guard.
Note that the feeding system only works when the
device is switched on.
Excess trimming line will be thrown out. Danger of injury for bystanders.
Trimming
Hold the device firmly with a gap between the device and your right side. Stand upright, do not lean forward
and pay attention to your posture. Keep both feet apart to help retain your balance.
Hold the cutting head just above the ground at an angle of approximately 30°. Move the device with a slow and
regular arc from left to right, before moving it back to the starting position and trimming the next area.
V. 01 – 20/09/2016
VL123
WARNING
6
©Velleman nv
Publicidad
