Publicidad
Idiomas disponibles
Idiomas disponibles
Trimmer Spool
Refer to the illustrations on page 2 of this manual.
Replace the trimmer spool when it is empty or worn.
1. Make sure the on-off switch is in the off position.
2. Turn the device over. Hold the trimmer head steady with one hand. Rotate the cover anticlockwise to
disengage the latches from the housing.
3. Remove the cover together with the trimmer spool. Discard all trimming line on the spool.
4. Clean the housing before inserting a new spool of the same type. Lead the trimming line endings through
the eyelets of the cover.
5. Refit the cover onto the housing and rotate it clockwise to secure it. Ensure the cover is correctly fitted
before releasing it.
9.
Troubleshooting
problem
The device does not start
The device does not reach full
power
Unsatisfactory results
Excessive vibration
10.
Technical Specifications
power supply ............................................................................................. 220-240 V~, 50 Hz
power consumption ...................................................................................................... 250 W
load speed ............................................................................................................. 12000 rpm
trimmer line
diameter ............................................................................................................... 1.2 mm
length ................................................................................................................... 2 x 3 m
cutting diameter ......................................................................................................... 230 mm
Use this device with original accessories only. Velleman nv cannot be held responsible in the event
of damage or injury resulting from (incorrect) use of this device. For more info concerning this
product and the latest version of this manual, please visit our website www.toolland.eu. The
information in this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman nv. All worldwide rights reserved. No part of this
manual may be copied, reproduced, translated or reduced to any electronic medium or otherwise without the
prior written consent of the copyright holder.
V. 01 – 20/09/2016
VL123
possible cause
Not connected to power supply
Power cord or plug is defective
Other electrical defect
Extension cord not suitable for
operation with this device
Power source has too low voltage
Air vents are blocked
Trimming spool is worn
Trimming spool is damaged
Bolt/nuts are worn
8
possible solution
Connect to power supply
Check by a qualified technician
Check by a qualified technician
Use a proper extension cord
Connect to another power source
Clean the air vents
Replace with a new one
Replace with a new one
Tighten bolts/nuts
©Velleman nv
Publicidad
