SEVERIN KS 9834 Instrucciones De Uso página 15

Warning: Always disconnect the unit from the mains before any maintenance or repair work is
carried out.
1. Remove the two screw covers (11) and
the screws (10).
2. Remove the entire top panel (9).
3. Remove the three threaded bolts (6)
securing the hinge plate (5) on the
right-hand side.
4. Carefully lift up the door and place it
on a suitable surface to protect it from
scratches.
5. Take off the protective corner-piece (7)
and re-fit it in the groove on the right-
hand side, pushing it firmly down.
6. Remove the hinge pin from the hinge
plate and screw it back in from the
opposite side.
7. Remove the two screws from the left-
hand side in the hinge plate mounting
and re-fit them on the right.
8. Remove the three screws (1) holding the lower hinge plate (2) on the right-hand side.
9. Remove the hinge pin from the lower hinge plate and re-fit it in the next hole.
10. Remove the adjustable foot (4) from the left-hand side and re-fit it on the right.
11. Attach the lower hinge plate (2). (Do not tighten the screws for the moment; this should only be
done once the door is in its proper closed position.)
12. Replace the door in its new position. Ensure that the hinge pin is inserted into the guide bushing
(hole) on the lower part of the door frame.
13. Attach the upper hinge plate (5) (removed earlier in step 3) on the left-hand side. Ensure that the
hinge pin is inserted into the guide bushing (hole) on the upper part of the door frame.
14. Adjust the closed door to its proper position and tighten the screws of the upper and lower hinge
plates.
15. Replace the top panel (9).
16. Replace the screws (10) und the screw covers (11) in the top panel (9).
17. Put the unit back in its intended position and wait for about two hours before connecting it to
the mains.
Temperature control
The temperature control automatically regulates the temperature inside the different compartments.
Min cold setting
Normal colder (normal) setting
Max coldest setting
Super intense freezing
Following a power interruption, or if the unit has been switched off on
purpose, it may take 3 to 5 minutes before it switches on again.
15