SEVERIN KS 9834 Instrucciones De Uso página 18

least twice a year with a hand-brush or a vacuum cleaner.
Trouble-shooting
Certain typical sounds can be heard when the appliance is switched on. These sounds are:
– caused by the electrical motor within the compressor assembly;
during compressor start-up the sound level will be slightly higher
for a limited period of time.
– caused by the cooling agent flowing through the circuit.
The following table lists the possible malfunctions, their probable causes and solutions. In the event
of operational problems , check first whether a solution can be found using this table. If the problem
persists, disconnect the appliance from the mains power and contact our Customer Service Departm
Problem
The unit is not working.
T h e u n it s e e ms to
generate insufficient
cooling power.
The normal operating
s o u n d c h a n g e s o r
becomes louder.
Transporting the appliance
The unit must be transported only in its vertical position.
Do not tilt it any more than 45°. During transport, ensure that the unit is properly secured and
protected against shock, vibration and shifting.
Disposal
This appliance has been manufactured from recyclable materials. After removing the plug
from the wall socket, the unit should be rendered unusable by cutting off the power cord
before being disposed of through special waste collection points in accordance with local
regulations. The refrigerant and the chemical agent in the insulation foam must be disposed of
through a competent agency. Take special care not to damage the cooling circuit before the unit is
handed over for competent disposal.
Possible cause and solution
Check that
– the switch in your home installation fuse box is switched on.
– the wall socket is working. This can be done by connecting another
electrical device to the socket and checking for function.
Check whether
– too much food has been stored in the unit.
– the thermostat is set to position ‚MIN' (in this case, set it to a
suitable higher value).
– the door is not properly closed.
– there is too much dust on the condenser.
– the unit is too close to a wall or other object at the rear or to the
sides.
Check whether
– the unit has been properly positioned.
– any objects or obstructions are touching the rear of the unit.
– there are any objects on top of the unit which might be vibrating.
18