Connecting To Microphones, Speakers And Video Monitors - Avigilon 1.0-H3-D1 Guia De Instalacion

Connecting to Microphones, Speakers
and Video Monitors
The camera can be connected to an external microphone, speaker
and video monitor through the audio/video connector. The connector
is a mini-jack (3.5 mm), and the pinout for it is shown in the following
diagram.
NOTE: The camera only supports line level mono audio input and an
NTSC or PAL video output.
The video output signal is determined by the camera flicker control
setting. When the camera flicker control is set to 60 Hz, the video
output signal is NTSC. When the flicker control is set to 50 Hz, the
video output signal is PAL. Use the Avigilon Camera Installation Tool
to configure the camera's flicker control in the Image and Display
setup.
NOTE: Video output is disabled when the camera is encoding multiple
H264 or JPEG streams. Use the Avigilon Camera Installation
Tool to configure the camera's Compression and Image Rate
setup.
Audio IN
Figure: Mini-jack audio video connector.
12
Composite
GND
Video OUT
Audio
OUT