Troubleshooting & Specifications - Sanyo SC-TA3000 Manual De Instrucciones

Before inquiring about service and maintenance, please check the following points listed
below.
TROUBLE
Power won't turn on even
when the on/off pedal
switch is turned on.
Suction power
has weakened.
The rotating brushes
won't turn.
Dirt and debris are flying
out from the exhaust vent.
POWER SUPPLY
POWER CONSUMPTION
CAPACITY OF DUST CONTAINER 0.8 Gallon
DIMENSIONS (W x D x H)
WEIGHT
POWER CORD LENGTH
ACCESSORIES
TROUBLESHOOTING
CHECK POINT
Is the power cord plug
firmly plugged into the
outlet?
Is the hose firmly attached
to the main unit?
Has dirt clogged up the
hose?
Did you check the "Max" fill
line to see if the dust
container is full?
Is dust and debris
clogging the filter?
Did you press the handle
release pedal?
Has dirt clogged up the
rotating brushes?
If the rotating brushes still won't turn after checking the
above points and possible solutions, an internal drive
belt in the floor nozzle may be broken. Contact an
authorized service center for further evaluation.
(See page11)
Have the filter and dust
container been correctly
attached?
SPECIFICATIONS
AC120V 60Hz
10 Amps
13-3/8" x 15-3/4" x 43-11/16"
14.3 lbs
25 ft
Floor nozzle (1), Crevice Tool (1), Handle (1),
Brush (1), Wand (1)
10
POSSIBLE SOLUTION
Insert power cord plug
firmly into the outlet.
(See page 5)
Make sure the hose is
attached. (See page 7)
Remove the clogged dirt.
Empty the dust container.
(See page 8)
Clean the filter.
(See pages 8-9)
Press the handle release
pedal and pull back on the
handle. (See page 6)
Remove the clogged dirt.
(See page 9)
Make sure they are
attached correctly.
(See page 8-9)