HoMedics AntiGravity Recliner AG-3002 Manual De Instrucciones página 3

AG-3002A 10/9/06 10:06 AM Page 5
Components
Carefully remove all contents from packaging and inspect the product
to make sure all components of the chair have been received. These should include:
• Left armrest A
• Right armrest with control panel B
• Front cross bar C
• Bottom cross bar D
• Back frame with attached cushion and massage mechanism E
• Seat frame with attached cushion F
• Large bolts and bolt sleeves for crossbars (8) G
• Washers and Caps/Nuts (8) H
• Small Allen wrenches I
• Optional softening pad J
• Detachable headrest K
• AC adaptor L
See Figure 1.
Figure 1
B
8
6
2
4
4
2
6
F
L
K
E
8
Output
Jack
7
3
D
1
C
A
Input
Jack
5
1
I
3
H
G
4
Easy to Follow Guide to Chair Assembly
1. Assemble Chair Base
• Attach the front cross bar C
the left armrest. Secure with the provided large bolts and bolt sleeves
bottom cross bar D to the left armrest ensuring the labeled "3" on the crossbar lines up with the "3" on the
armrest. Secure with the provided large bolts and bolt sleeves using the allen wrench.
DO NOT FULLY TIGHTEN BOLTS AT THIS POINT. See Figure 2.
• Attach right armrest B to cross bars C
with the "2" and "4" on the armrest. Secure with large bolts and bolt sleeves using the allen wrench.
See Figure 3.
• Tighten all bolts, ensuring the base sits level without wobbling.
NOTE: ASSEMBLE BASE ON ITS SIDE.
C
D
A
2. Attach Seat Cushion/Frame to Base
• Align the seat with pre-attached bolts. From the bottom side add washer and caps/nuts to secure the
Seat frame to the base. See Figure 4.
• Use the provided allen wrench to tighten partially.
J
NOTE: IT MAY BE EASIER TO TURN THE BASE ON ITS SIDE TO INSERT THE BOLTS.
3. Attach Back Cushion/Frame to Base
• Align the back with the pre-attached bolts to the frame. From the back side, add washer and caps/nuts to secure to
Back frame to Chair Base. See Figure 5.
• Attached correctly, the back frame will form a concave shape and fabric stitching should face up. See Figure 6.
• Tighten all caps/nuts using the allen wrench.
to left armrest A by lining up the labeled "1" on the cross bar with the "1" on
G using the allen wrench
D making sure to line up the labeled "2" and "4" on the cross bars
B
C
D
A
Figure 2 Figure 3
Figure 4
Figure 5
5
I . Attach the
Figure 6