Alesis SamplePad 4 Guia Del Usuario página 6

Editing Layer Parameters
To adjust the pitch of a sample:
1. Strike a pad or ext. trigger.
2. Move the cursor to the TUNE area by pressing the Cursor Up or Cursor Down buttons.
3. Then press the Cursor Left or Cursor Right button to adjust the tuning. [-4, -3, -2, -1, 0, 1, 2, 3, 4]
To adjust the reverb level of a sample:
1. Strike a pad or ext. trigger.
2. Move the cursor to the REV (Reverb) area by pressing the Cursor Up or Cursor Down buttons.
3. Then press the Cursor Left or Cursor Right button to adjust the reverb level. [0-10]
To adjust the sensitivity of the pad or ext. trigger:
1. Strike a pad or ext. trigger.
2. Move the cursor to the SENS (Sensitivity) area by pressing the Cursor Up or Cursor Down buttons.
3. Then press the Cursor Left or Cursor Right buttons to adjust the sensitivity level. [1-8]
To adjust the volume level of a sample:
1. Strike a pad or ext. trigger.
2. Move the cursor to the LEV (Level) area by pressing the Cursor Up or Cursor Down buttons.
3. Then press the Cursor Left or Cursor Right button to adjust the level. [0-10]
To adjust the panning of a sample:
1. Strike a pad or ext. trigger.
2. Move the cursor to the PAN area by pressing the Cursor Up or Cursor Down button.
3. Then press the Cursor Left or Cursor Right button to adjust the pan position. [L4, L3, L2, L1, CTR, R1, R2,
R3, R4]
To adjust the MIDI note sent by the Trigger Location:
1. Strike a pad or ext. trigger.
2. Move the cursor to the MIDI area by pressing the Cursor Up or Cursor Down button.
3. Then press the Cursor Left or Cursor Right button to adjust the MIDI note number. [00-127]
Note: The MIDI note does not have an effect on the internal sound.
6