Toto EcoPower Manual De Instrucciones página 5

To Install Helix and Libella Wall-Mounted Models (ill. 5):
NOTE: The addition of a 2 x 4" stringer behind the spout installation location is highly
recommended.
1. Place mounting template on wall at desired
location and mark all holes. Drill a 5/8" (16 mm)
diameter hole at the spout mounting location
(center) for the supply tube and sensor cord to
pass through.
2. For fastening to wood , drill three (3) pilot holes
7/64" (2.7 mm) in diameter at marked locations.
For fastening to drywall or tile, drill three (3) holes
3/16" (5 mm) in diameter and insert anchors until
flush. Tap lightly with a hammer if needed.
To Install Helix Wall-Mounted Models (ill. 6):
3. Feed the supply tube and sensor cord through
the 5/8" (16 mm) hole in center.
Place spout against wall and fasten securely with
the provided screws.
. 4 F s a e t n h t e e c s t u h c
hand-tight.
To Install Libella Wall-Mounted Models (ill. 7):
3. Place mounting bracket against wall and fasten
securely with the provided screws.
4. Pass the hose and sensor cord through the
mounting bracket, slide the spout base over the
mounting bracket and tighten the set screw to
secure the spout to the mounting bracket.
To Install Gooseneck Wall-Mounted Models (ill. 8, 9 & 10):
NOTE: Confirmation of wall strength is highly recommended before drilling.
. 1 D l i r a l 1 1 - 8 / ( " 9 2
for the mounting bracket. Place the mounting
bracket through a hole in the wall with the set
screw hole located at 12 o'clock. Mark the
location of the set screw hole on the wall and
remove the mounting bracket.
For sheet metal surface: Drill a 3/16" (5 mm) hole at the marked location.
NOTE: Drill bits (not supplied) for hard materials may be required.
For a drywall/hollow wall surface: Drill a 1/4" (6.5 mm) hole at the marked location, and install
the included wall anchors.
NOTE: The addition of a 1 x 6" or plywood bracing behind the mounting location is highly
recommended for drywall/hollow wall installations. The overall maximum wall
thickness is 2" (50 mm).
INSTALLATION PROCEDURE
e o n o t h t e r b c a e k t until
m m ) h o e l t a h t e d e i s
STEP 8
ill. 5
2 x 4
Stringer
2 x 4
Studs
ill.6
ill.7
Mounting
Bracket
Set Screw
e r d o l c t a o i n
Hole for set screw/machine
ill. 8
screw and wall
anchor
Hole for mounting bracket
5
Finished Wall
5/8" Hole for
spout
Holes for screws/
anchors
Escutcheon
Ø 3/16" (sheet metal surface)
Ø 1/4" (drywall/hollow wall)
Ø 1-1/8"