Unitekno C200A Manual De Uso página 10

WARNING!
Do not use this machine if there are
signs of damage (cracks, breaks),
if the power cord is damaged, or if
you suspect that there may be an
internal defect (for example, after the
machine has fallen).
If the power cord is damaged, a
manufacturer-authorised service
centre must replace it since a special
tool is needed to access it.
Read the rating-plate located under
the machine; make sure the voltage
and input ratings comply with the
system's capacity.
Plug the machine into a grounded
outlet.
While moving the machine, avoid
tugging on the power cord.
Disconnect the machine from the
electrical power source by pulling the
plug. Do not disconnect it by pulling
on the cord, since this could damage
the machine.
8
Do not leave the machine unatten-
ded while it is plugged in.
Remove the power supply plug
from the socket after use and for
manteinance.
This appliance is not intended for
use by persons (including children)
with reduced physical, sensory or
lack of experience and knowledge
unless they have been given su-
pervision or instruction concerning
use of the appliance by a person
responsible for their safety.
Children should be supervised
to ensure that they do not play
with the appliance. Do not attach
devices that exceed the indicated
input rating to the machine!
Only use the machine's original
accessories, which are guaranteed
compatible by the manufacturer.
Do not attach devices that exceed
the indicated input rating to the
machine!
Only use the machine's original
accessories, which are guaranteed
compatible by the manufacturer.
This machine has been manufac-
tured for use in enclosed (covered)
areas.
Do not submerge the machine in
water!
Do not point the steam jet
at persons or other living
beings. This machine pro-
duces high-temperature
steam. Avoid direct contact with
the skin. ATTENTION! Danger of
burning.
Vapor must never be directed
toward equipment containing
electrical parts, like the inside of
ovens.
Do not place any type of substance
(detergents or anything else) in the
boiler if not specifically approved by
the manufacturer.
Before using the machine to clean
surfaces that may get damaged
(e.g. synthetic fibres, plastics,
wood, etc.), check their capacity
to withstand high temperatures by
doing a trial run on a hidden area
and by carefully following manufac-
turer's instructions.
Only use original replacement parts
for any necessary repairs. Please
see an authorised service centre.
Disconnect the equipment from the
electrical system before proceeding
with cleaning or maintenance
operations.
The aperture for cleaning the boiler
must not be open during use.