Unitekno C200A Manual De Uso página 16

MAINTENANCE
A certain amount of deposit will form
inside the heater according to how
much it is used and how hard the
water is.
HOW TO REMOVE DEPOSIT
FROM THE HEATER
Check that no accessory is connec-
ted to the steam generator. Unscrew
the metal cap on top of the heater
unit. Pour 1/2 a glass of white wine
vinegar into the empty heater and
screw on
DISPOSAL INSTRUCTIONS AND ENVIRONMENTAL PROTECTION STANDARDS
The technical data and information given in this handbook are not binding. UNITEKNO reserves the right to carry out any
necessary modifications without prior notice or replacement.
14
the cap. Make sure that there is
water in the cold water reservoir.
Switch on the heater until the correct
temperature has been reached.
Switch off the appliance and wait un-
til the internal pressure has subsided.
Unscrew the metal cap again, empty
the heater and rinse thoroughly with
clean water.
Close by screwing on the metal cap.
Do not empty the steam through the
iron or the nozzle.
Dispose of packaging and used filters in accordance with current standards. Follow the instruc-
tions for any material recycling (segregated collection) in your area. This product conforms to the
2012/19/EU Directive. The symbol of a crossed out basket on the device specifies that the
product should be disposed of separately from domestic waste at the end of its useful life. The
user is responsible for taking
the expired device to an appropriate collection point. Suitable segregated collection for ensuing
recycling, treatment and environmentally compatible disposal helps prevent potentially negative
effects on the environment and on health and favors recycling of the product's materials. For
more detailed information on available collection systems, consult your local waste disposal
service or the shop where the product was purchased.
HOW TO REMOVE DEPOSIT FROM
THE COLD WATER RESERVOIR
The cold water reservoir is controlled
by sensors, which may not work
properly when there is calcium
build-up. Therefore occasionally it is
necessary to pour 1/2 glass of white
vinegar in the cold water reservoir,
and then to spray a generous amount
of steam into the reservoir using the
steam nozzle. Following this opera-
tion, rinse well with water.