Operating Conditions; Settings And Adjustments - Bevel Tools Mate ABA 3.0 Instrucciones De Funcionamiento

2.5 Operating conditions

Temperature range during operation: 0 to +50°C
Relative air humidity: 95% at +10°C not condensed
i

3.1 Settings and adjustments

The machine may only be operated with the flange head!
Screw on the front which closes the
oil reservoir. (screw not visible on
this image)
3.1.2 Mounting a bevel head
• Place bevel head on the adapter. The pin on the adapter should easily
fit into the pinhole in the Bevel Head.
• Lock spindle with the locking button.
• Use the Hex wrench (5 mm) to tighten the guide bearing.
• Check bevel tool before use. The bevel head must be correctly
mounted and must rotate freely. Perform a trial run over a period
of min. 30 seconds without load. Do not use bevel heads which are
damaged, which do not run true or which vibrate!
Rotate flange head counter-clockwise to decrease cutting
depth and clockwise to increase cutting depth.
EN
Attach air fitting here
6 bar/90 PSI (1/2" Air Hose Rec'd)
1390 ltr/min / 49 CFM
Spindle lock button
4
ON/OFF handle