OPERATION
Electronic programmer
MENU - select the mode of operation
>
- higher setting sensor
<
- lower setting sensor
- appliance on indicator
- kitchen timer
- Duration
- End Time
Setting the time
When the appliance is plugged into the electri-
cal mains supply, or when power is restored
after power outage, the digital display will
show flashing 0.00:
● Touch and hold MENU (or simultaneously
touch < and >) until you will see
display and the dot below the symbol is
flashing.
● Touch < or > within 7 seconds to set the
current time.
To store the new time setting, wait approxi-
mately 7 seconds after time has been set.
The dot below the
symbol will stop flashing.
You can adjust the time later. To do this touch
< and >, simultaneously and adjust the cur-
rent time while the dot below the
is flashing.
Note:
The oven can be turned on when you see the
symbol on the display.
Kitchen Timer
You can active the Kitchen Timer at any time,
regardless of the status of other functions. The
Kitchen Timer can be set from 1 minute up to
23 hours and 59 minutes.
To set the Kitchen Timer:
● Touch MENU, then the display will show
blinking .
● Use the < and > sensors to set the Kitchen
Timer. The display will show the set time
and Kitchen Timer symbol . Once the set
time elapses, alarm sounds and the icon
flashes.
● Touch and hold the < / > or MENU to mute
the alarm. The will be off and the display
will show the current time after approxi-
mately 7 seconds.
Note:
If no button is touched, alarm will turn off
automatically after approximately 7 minutes.
on the
symbol
41