For Your Safety - WIKA OBSOLETE WU-10 Manual De Instrucciones

5. For your safety

5. For your safety
Warning!
Select the appropriate transducer with regard to scale range, performance and specific measurement
■
conditions prior to installing and starting the instrument.
Observe the relevant national regulations (e.g.: EN 50178) and observe the applicable standards and
■
directives for special applications (e.g. with dangerous media such as acetylene, flammable gases or
liquids and toxic gases or liquids and with refrigeration plants or compressors). If you do not observe the
appropriate regulations, serious injuries and/or damage can occur!
Open pressure connections only after the system is without pressure!
■
Take precautions with regard to remaining media in removed pressure transmitter. Remaining media in the
■
pressure port may be hazardous or toxic!
Disconnect the instrument before connecting up to the power supply.
■
Make sure that all parts are protected against direct contact when installing the device and making
■
connections.
Configure the system with particular care when connecting up to other equipment.
■
Please make sure that the transducer is only used within the overload threshold limit all the time!
■
Observe the ambient and working conditions outlined in section 7 „Technical data".
■
Ensure that the transducer is only operated in accordance with the provisions i.e. as described in the
■
following instructions.
Do not interfere with or change the transducer in any other way than described in these operating instruc-
■
tions.
Remove the pressure transmitter from service and mark it to prevent it from being used again accidentally,
■
if it becomes damaged or unsafe for operation.
Have repairs performed by the manufacturer only.
■
The operator is responsible for the material compatibility as well as correct handling, operation and mainte-
■
nance.
The safety of the user can be detrimentally influenced by the equipment if e.g.:
■
- visible damage is apparent
- it cannot be operated any longer as stipulated
- it has been stored over a longer period under unsuitable conditions.
In cases of doubt the device should be returned to the manufacturers for repair and servicing.
Information about material consistency against corrosion and diffusion can be found in our WIKA-Handbook, 'Pressure and
Temperature Measurement'.
WIKA Operating instructions/Betriebsanleitung/Mode d'emploi/Instrucciones de servicio WU-1X
GB
5