Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
L evel R e f r i g e ra t o r
NOTE: Custom or full-overlay door panels must be installed
before leveling.
1. Open the door and place the level on top of the refrigerator
frame as shown. Check to see whether the refrigerator is level
from left to right.
A
B
A. Level to check left to right leveling
B. Level to check front to back leveling
2. Use the leveling bolts to adjust the leveling legs until the
refrigerator is level from left to right.
A
B
A. Rear leveling bolt
B. Front leveling bolt
3. Place the level(s) on shelf or shelves. Check to see whether
the refrigerator is level from front to back.
4. Use the leveling bolts to adjust the leveling legs until the
refrigerator is level from front to back.
5. Be sure that all four leveling legs contact the floor and
support the full weight of the refrigerator.
6. Make final check to ensure the refrigerator is level.
A d j u s t D o o r Sw i n g
1. Check that the refrigerator door can open freely. If the door
opens too wide or you are installing full-overlay custom
panels using a Trimless Trim Kit, you should adjust the door
swing.
2. Remove the door stop screw from the bottom hinge.
A
A. Door Stop in 130° position
B. 110° position
C. 90° position
3. Hold the door open to a position that is less than 90°.
20
A
B
B
C
4. Replace the door stop screw in the bottom hinge and tighten.
NOTE: If you are using full-overlay custom panels with the
Trimless Trim Kit, the door stop should be replaced in either
the 90° or 110° position. See "Handle and Door Clearances
for Custom Panel Series."
A. Door stop screw in 110° position
I n s t a l l S i d e Pa n e l
If the built-in area depth is 25" (63.5 cm) or more, the side panels
can be installed inside the side trim or attached to the outside of
the side trim.
IMPORTANT: Thermador is not responsible for the removal or
addition of molding or decorative panels that would not allow
access to the refrigerator for service.
1. For the inside side trim piece, slide the front edge of the
routed side panel into the trim piece.
2. Nail the rear edge of the panel to the support board.
A
B
A. Support board
B. Side trim piece
A
Publicidad
Tabla de contenido
