Elvox EA60 Manual De Instrucciones página 9

INSTALLATION OF FASTENING PLATES
Fix the back plate to the pillar.(FIG. 1)
Anchor the rear part of the piston to the plate and fasten it firmly (FIG. 2)
(FIG. 2)
Warning! When establishing the height off the ground at which to fasten the plate to the post (fig. 1), keep in mind that the plate for
anchoring the piston to the gate must be fastened at thesame level (fig. 3)
Installing the anchor plate on the piston to the gate
1. Fit the anchor plate onto the piston (fig. 4)
2. Close the gate
3. Move the piston with the plate already fitted towards the gate
4. Move the fitting to limit stop, then move it back by approximately 1
cm and mark the position of the plate.
5. realize the same operation in opening.
6. If positions correspond, fix the plate on the gate; otherwise revise A
and B units (table 1)
Release procedure
To unblock the operator, use the key as
shows the photo.
Turning the key of 90°, the operator will
be completely unblocked.
EA60 - EA80
Blocked
9/28
GB
(FIG. 1)
(FIG. 3)
(FIG 4 (FIG. 4) G.
(FIG. 4)
(FIG. 5)
Unblocked