Descargar Imprimir esta página

Cut Regulation; Shredding Degree Adjustment; Side Movement; Useful Tips - breviglieri turbo t 120 sr Serie Instrucciones De Empleo Y Mantenimiento

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

4.4.1 CUT REGULATION

Cutting height regulation is a dangerous operation. Wear work gloves and use suitable tools in a good condition.
Proceed in the following way to adjust the cutting height:
Park the tractor on a flat surface and hitch the machine then raise it with the power lift
Place two strong stands at the sides of the machine to protect yourself if it should fall
Lower the machine on to the stands, turn off the tractor engine and apply the parking brake
The cutting height is established by the position of the bearing roller on the
machine (Fig. 7). To change the position, slacken off the bolts (1 Fig. 7) on both
sides, then remove them from one side and move the roller either down or up
depending on the required cutting height. Fit the bolts back in place and repeat
the operation on the other side. Now carefully tighten all the bolts. A taller
cutting height is obtained with the roller in the lower position while the cutting
height will be shorter when the roller is higher up. This is because the machine
is furthered or neared to or from the ground. Once the bearing roller has been
adjusted and the machine lowered to the ground, adjust the third point of the
machine so that it is parallel to the ground.

4.4.2 SHREDDING DEGREE ADJUSTMENT

Cutting height regulation is a dangerous operation. Wear work gloves and use suitable tools in a good condition.
Proceed in the following way to adjust the cutting height:
1.
Park the tractor on a flat surface and hitch the machine then raise it with the power lift
2. Place two strong stands at the sides of the machine to protect yourself if it should fall
3.
Lower the machine on to the stands, turn off the tractor engine and apply the parking brake
Open or close the rear casing (2 Fig. 7) to adjust the degree to which the plants are shredded. The casing has various positions. The
more it is closed, the finer the plants will be shredded. To improve the shredding operation, the machine can be equipped with rear
rakes (Fig. 8) which only allow the material to come out after it has been finely shredded. This is convenient when pruning residues
or other plants that have not been cut by the machine during its run need to be collected, since they are kept under the casing
and shredded again. Regulate the harvesting blades by raising or lowering them but do not allow them to touch the ground. Their
adjustment therefore functions according to the actual ground itself. If large twigs must be cut, the knives must be kept in a higher
position. Vice versa, they must be set in a lower position if the twigs are smaller so that the material is held back if it is not cut.

4.4.3 SIDE MOVEMENT

To move the cutter sideways when the machine is equipped with a hydraulic circuit, insert the two pins at the end of the hose pipes
into the relative unions on the tractor.
Cutter movement will then be controlled from the driver's seat by means of the levers of the hydraulic valve system of the actual
tractor itself.

4.4.4 USEFUL TIPS

Here are a few useful suggestions on how to resolve some of the problems that may occur during work.
Cut plants shredded too much
Slightly lift the cutter from the ground, adjusting the height with the wheels (the blades of the cutter must not touch the
ground).
Increase the ground speed.
DANGER
DANGER
- 31 -
turbo t 120 sr
Fig. 6

Publicidad

loading