Operating The Appliance; Setting The Fan; Intensive Setting; Fan Run-On Time - Siemens LC98KA.71 Instrucciones De Uso

Operating the appliance

These instructions apply to several appliance variants. It is
possible that individual features are described which do not
apply to your appliance.
Note: Switch on the extractor hood when you start cooking and
switch it off again several minutes after you have finished
cooking. This is the most effective way of removing the kitchen
fumes.
Control panel
Explanation
1 Switch the fan on/off
2 Switch on the lighting
3 Turn the fan down
4 Display panel
5 Switch up the fan setting
6 Switch on intensive mode
7 Switch on fan run-on

Setting the fan

Note: Always adjust the fan strength to meet current conditions.
If there is a large build-up of steam or fumes, select a high fan
setting.
Switching on the appliance
Press the button.
#
1.
The fan starts at setting 1.
Press the "+" or "-" buttons to set another fan setting.
2.
Switching off the appliance
Press the 0 button.

Intensive setting

You can use the intensive setting if there is a large build-up of
odours and fumes/vapours.
Press the button while ventilation is switched on.
›
1.
The intensive setting is activated.
Press the › button.
2.
The intensive setting is deactivated.
Note: The intensive setting run time is 6 minutes. Once this
time has elapsed, the appliance switches back to the fan
setting that was previously set.

Fan run-on time

Press the button.
x
1.
The fan continues to run at this fan setting for 15 minutes and
then switches off automatically after this time. The current fan
setting and the remaining run-on time in minutes are
displayed alternately in the display panel. If the lighting is
switched on, this is also switched off after the run-on time.
Press the button again.
x
2.
The fan run-on ends before the end of the remaining run-on
time.

Lighting

The lighting can be switched on and off independently of the
ventilation.
Press the @ button.
Setting the brightness
Press and hold the @ button for two seconds.
1.
The brightness is reduced.
Press the @ button.
2.
The maximum brightness is restored.

Saturation display

When the metal grease filter or activated charcoal filter is
saturated, the corresponding symbol flashes:
Metal grease filter: ª
■
Activated charcoal filter:
■
When this happens, do not delay cleaning the metal grease
filter or replacing the activated charcoal filter any further.
For instructions on how to clean the metal grease filter, please
refer to the section "Cleaning and maintenance".
Restoring the saturation displays
Switch off the motor.
1.
Press and hold the "-" button for two seconds.
2.
Switching over the display for circulating-air mode
For circulating-air mode, the electronic control display must be
switched over accordingly:
Check that the extractor hood is connected and switched off.
1.
Press and hold the "+" button for two seconds.
2.
flashes twice, i.e. the electronic control is switched over to
'
circulating-air mode.
Press the "+" button.
3.
flashes once, i.e. the electronic control is switched back to
'
exhaust-air mode.
'
13