Schumacher Electric SPI3 CANBUS Manual Del Propietário página 8

RING TERMINAL QUICK-CONNECT
The ring connectors permanently attach to the battery, providing easy access to quickly
charge your battery. This application is appropriate for motorcycles, lawn tractors, ATVs
and snowmobiles.
1. To permanently attach to a battery, loosen and remove each nut from the bolts at the
battery terminals.
2. Connect the red positive connector ring to the positive (POS, P, +) battery terminal.
3. Connect the negative connector ring to the negative (NEG, N, -) battery terminal.
4. Replace and tighten the nuts to secure them.
5. Connect the ring connector cable assembly to the charger. Take care to keep both wires
and plug away from hot and moving parts.
6. Plug the charger power cord into an AC electrical wall outlet. Make sure to place the
charger on a dry, non-flammable surface.
7. Select the battery type.
8. When charging is complete, disconnect the AC cord from the supply mains, remove the
negative connector, and finally the positive connector.
CANBUS ADAPTER QUICK-CONNECT
1. Connect the end of the charger output cable to the end of the CANBUS adapter
quick-connect.
2. Connect the BMW/CIG connector of the CANBUS adapter quick-connect to the
cigarette lighter socket of the motorcycle.
3. After a good electrical connection is made to the motorcycle, plug the power cord into an
AC electrical wall outlet. Make sure to place the charger on a dry, non-flammable surface.
4. Select the battery type and charging program.
5. When charging is complete, disconnect the AC cord from the supply mains, and then
remove the CANBUS adapter quick-connect.
BATTERY CONNECTION INDICATOR
If the charger does not detect a properly connected battery, charging will not start and the
digital display will show one of two messages. If the display shows CONNECT CLAMPS,
make sure the charger is connected to the battery and the connection points are clean and
making a good connection. If the display shows WARNING-CLAMPS REVERSED, unplug
the charger from the AC outlet, reverse the connections at the battery, and then plug the
charger back in.
AUTOMATIC CHARGING MODE
When an Automatic Charge is performed, the charger switches to the Maintain Mode
automatically after the battery is charged. For a battery with a starting voltage under 1 volt,
use a manual charger to pre-charge the battery for five minutes, to get additional voltage
into the battery.
ABORTED CHARGE
If charging cannot be completed normally, charging will abort. When charging aborts, the
charger's output is shut off, the green LED will flash, and the display will show CHARGE
ABORTED-BAD BATTERY. To reset after an aborted charge, unplug the charger from the
AC outlet, wait a few moments and plug it back in.
COMPLETION OF CHARGE
Charge completion is indicated by the pulsing green LED and the digital display showing
FULLY CHARGED-AUTO MAINTAINING. This indicates the charger has switched to the
Maintain Mode of operation.
• •
8