14. EU Declaration of Conformity and declaration of
incorporation of "partly completed machinery"
Document
Language
Revision
Manufacturer's Name:
Address:
Authorized Person to constitute the technical documentation:
Address:
Type of product:
Model/Type:
Accessories:
The undersigned, Giorgio Zanutto, in the role of Chief Executive Officer, declares under his sole responsibility, that the product specified
above conforms to the provisions of the following directives:
• Directive 2014/30/UE (EMC)
· EN 61000-6-2:2005
· EN 61000-6-3:2007 + A1:2011
The product also complies with the following directives according to the requirements envisaged for "partly completed machinery" (Annex
II, part 1, section B): Directive 2006/42/EC OF THE EUROPEAN PARLIAMENT AND COUNCIL of 17 May 2006 related to machinery, and
which amends the directive 95/16/EC (recast).
• It is hereby declared that the pertinent technical documentation has been compiled in compliance with appendix VII B of directive
2006/42/EC and that the following essential requirements have been observed: 1.1.1- 1.1.2- 1.1.3- 1.2.1-1.2.6- 1.5.1-1.5.2- 1.5.5-
1.5.6- 1.5.7- 1.5.8- 1.5.10- 1.5.11
• The manufacturer undertakes to transmit to the national authorities, in response to a motivated request, all information regarding the
"partly completed machinery", while maintaining full rights to the related intellectual property.
• Should the "partly completed machinery" be put into service in a European country with an official language other than that used in this
declaration, the importer is obliged to arrange for the relative translation to accompany this declaration.
• The "partly completed machinery" must not be used until the final machine in which it is incorporated is in turn declared as compliant, if
applicable, with the provisions of directive 2006/42/EC.
The product also complies with the following standards:
EN 60335-1:2012+A11:2014, EN 62233:2008
EN 60335-2-103:2015
Place and Date: Sacile 13/09/2018
Giorgio Zanutto
(Chief Executive Officer)
N. 1119
English (translated from Italian)
0
KING GATES S.r.l.
Via Malignani, 42 - 33077 - Sacile (PN) Italy
KING GATES S.r.l.
Via Malignani, 42 - 33077 - Sacile (PN) Italy
24VDC electromechanical gear motor for swing gates
COUPER 24
refer to the catalog
21