T260 Pick & Place - jbc RMVE-C Serie Manual De Usuario

T260 Pick & Place
This tool helps you easily place and remove SMDs of any size using the suction provided by the station.
Press the button to
start/stop the suction
Pick & Place
Ref. T260-A
Choose the suction cup that best fits the component (Maximum working temp.: 250ºC / 482ºF):
Insert the needle
with the appropriate
cup for a correct
suction process.
Operation
1. Suction
Once activated
the suction button,
cover the pen hole
with your finger and
pick the component.
12
You should avoid the
needle to stick out of
the lower part.
2. Release
Lift your finger
to release the
component on the
appropriate place.
Operation with JT station
1. Placing 2. Heating
Position the suction cup. Push the button for hot air
heating. The solder melts.
Process Control
Manual mode
Time to stop
T e m p º C
400 85
Current temperature
400 º C Select
Selected temperature
Power 70%
Access Menu (pess key 2 seconds) & Confirm Selection
You can switch between operating modes (Manual Mode / Profile Mode) by pressing the "increa-
se" and "decrease" keys simultaneously for 2 seconds. (Only when mode profiles is ON)
w w w.jbctools.com
3. Releasing
The component lifts off
automatically.
45 seconds
A i r %
% Instant power supplied
to heater
13