jbc RMVE-C Serie Manual De Usuario página 8

Program mode
º C
Graph of selected
program
Decrease program
number
Program Options
Edit Program
This option allows you to edit or create a program.
First , you must select the program to edit and then modify the points that make up the program.
Each program is composed of 9 points, each point consisting of 3 parameters:
1. Time (seconds)
2. Temperature (°C / °F)
3. Flow rate (%)
You can delete the last point of the program by selecting "-----" in the time parameter.
It should be taken into account that the regulation range permitted by the station is 150-450°C,
whereby it is not possible to create temperature ramps between room temperature (Toff) and
150°C.
The station can store up to 25 temperature programs.
The first three programs are edited by JBC as an example.
Copy Program
This option allows you to copy a program.
You must select the program source and the program destination (where it will be copied).
Delete Program
This option will allow you to delete a previously selected program.
14
P r o g r a m 8
Selected program
T e m p º C
380
Current temperature
Air 100%
Selected flow
Time 125s.
Remaining time
Increase program
number
Menu screen
Original PIN: 0105
M a i n m e n u
1 Reset settings
2 Station Settings
3 Program Settings
4 Counters
5 Program version
S e t t i n g s
1 Temp unit Celsius
2 Maximum temp 450 C
0
3 Minimum temp T OFF*
4 Fix temp 400 C
0
5 Temp Adjust 0 C
0
6 Max air 100%
7 Min air 10%
8 Fix air 40%
9 Time to stop 120 sec
10 Beep ON
11 Pop up ON
12 Change PIN
B a c k
* Selecting Minimum Temp to
"T OFF" allows for blowing at
ambient temperature.
C o u n t e r s
1 Station ON hours
2 Works hours
3 Works cycles
w w w.jbctools.com
E x i t
P r o g r a m S e t t i n g s
1 Programs
2 Edit program
3 Copy program
4 Delete program
E d i t P r o g r a m
º C
S e l e c t
P r o g r a m
8
E d i t P r o g r a m 8
º C
S t e p
T i m e
T e m p
A i r
E x i t
0
0
0
B a c k
4
2 0
4 5 0
1 0 0
15