Dr560 Tip Care; Mse Initial Setup; Mse Changing The Pump Filters - jbc RMSE-B Serie Manual De Usuario

DR560 Tip Care

The intake tube should be periodically cleaned by the largest rod.
Important
DO NOT press the vacuum pump button while tinning the desoldering tip, as the fumes given
off by the flux would quickly block the ducts and the air filter.
Desoldering process
Use a tip with a larger diameter than the pad to achieve maximum aspiration and thermal efficiency.
1. Placing 2. Rotating
Place the tip with the When the solder liquefies,
component terminal in the gently rotate the tip so that
hole. the compo nent terminal can
be lifted off.
After pressing the desoldering key there is a slight delay until the self-contained vacuum pump
stops. This makes sure that the vacuum circuit is completely empty. If any solder remains are left
on a terminal after desoldering it, resolder it with fresh solder and repeat the desoldering operation.
24
3. Aspirating
Press the vacuum pump
button long enough to remove
the solder.

MSE Initial Setup

After connecting the electric desoldering module (MSE-A), enter the Peripherals
Menu and select the port which you want to join with the module.
Peripherals
1. Select the module from the list of
peripheral connections. Remember your first
connection is denoted as "a", the second
being "b", etc. (e.g. MSE_a, MSE_b,...)
2. Press Menu or Back to save changes.
Once set up, you can change the module
settings by entering the Peripherals Menu.

MSE Changing the pump filters

- Clean the casing with a damp cloth. Make sure to use a soft cloth when cleaning the front.
- Periodically check all cable and tube connections.
- Keep filters clean to ensure proper solder suction and replace them when necessary.
Important
Suction filter
Do not use sharp Ref. 0821830
pointed objects
to open the
suction filter.
Cotton filters
Ref. 0781046
O Ring
Ref. 0007717
Filter cover
Ref. 0004710
w w w.jbctools.com
17:14
Peripherals
Port 2-DR
Pedal None
Module
Module None
MSE_a
None
Spare filters
Ref. 0005966
25