EAS ELECTRIC EMD09X2-V1 Manual De Instrucciones página 55

If the supply cord is damaged, it must be replaced by
the manufacturer or its service agent or a similarly
qualified person in order to avoid a hazard.
During installation, the power supply must not be
excessively or dangerously bent or flattened.
Do not tamper with controls.
The appliance needs to be connected to the main
water valve using new hose sets. Old sets should not
be reused.
To save energy, in stand by mode, the appliance will
switch off automatically while there is no any
operation in 15 minutes.
The maximum number of place settings to be washed
is 9.
The maximum permissible inlet water pressure is
1MPa.
The minimum permissible inlet water pressure is
0.04MPa.
6 V.2