Starting A Cycle Wash; Changing The Program Mid-Cycle - EAS ELECTRIC EMD12X3-V1 Manual De Instrucciones

Saving Energy
1. Pre-rinsing of tableware items leads to increased water and energy
consumption and is not recommended.
2. Washing tableware in a household dishwasher usually consumes less
energy and water in the use phase than hand dishwashing when the
household dishwasher is used according to the instructions.

Starting A Cycle Wash

1. Draw out the lower and upper basket, load the dishes and push them
back. It is commended to load the lower basket first, then the upper
one.
2. Pour in the detergent.
3. Insert the plug into the socket. The power supply refer to last page
"Product fiche". Make sure that the water supply is turned on to full
pressure.
4. Close the door, press the Power button, to switch on the machine.
5. Choose a program, the response light will turn on. Then press the
Start/Pause button, the dishwasher will start its cycle.

Changing The Program Mid-cycle

A wash cycle can only be changed if it has been running for a short time
otherwise, the detergent may have already been released and the
dishwasher may have already drained the wash water. If this is the case,
the dishwasher needs to be reset and the detergent dispenser must be
refilled. To reset the dishwasher, follow the instructions below:
1. Press the Start/Pause button to pause the washing.
2. Press Program button for more than 3 seconds - the program will
cancel.
3. Press the Program button to select the desired program.
4. Press the Start/Pause button, after 10 seconds, the dishwasher will
start.
3 sec
43
V.2