Cembre B1300-C-KV Manual De Uso página 11

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

102.3 kN
NR 14AF035
P
= 692 bar
692 bar
m
565 bar
max.
min.
The capacitive menu selection button may not work if touched using
objects or when wearing gloves, therefore always operate it using a bare finger.
BATTERY
BATTERY
4.2) SELECTION SCREENS:
of the tool, can be changed by operating the touch button:
Enabling/disabling the LED Worklights
BATTERY 
LED
ON
LED
BATTERY
OFF
13001
Return to original factory settings / firmware version
When the 'RESET' screen is displayed, return the tool to its factory setting by operating the touch
button for at least 3 seconds; a beep will confirm the setting.
RESET
SW:S1J41AH
4.3) WARNINGS:
of the tool:
LED
OFF
LED
BATTERY 
ON
BATTERY
13001
RESET
SW:S1J41AH
11
OK
B1300
To make a selected screen operational and appear at each start-up of the
OK
tool, operate the touch button for at least 3 seconds; a continuous beep
will confirm the setting.
3 SEC.
control parameters that cannot be set as automatic upon start-up
3 SEC.
The RESET screen also shows the firmware version of the circuit board.
these appear during operation and notify the operator of the status
LOW BATTERY: replace the battery.
NOTE: when the battery Vage falls below a minimum safety threshold, the tool
will not start; although it is still possible to end the work cycle in progress.
BATTERY TEMPERATURE HIGH: remove the battery and wait until it cools
down.
NO. OF CYCLES TO MAINTENANCE REACHED:
the tool continues to work however, it is recommended that it is sent to Cembre
for a complete overhaul (see § 6).
NOTE: this message, together with a beep, will reappear when the tool has been
idle for 30 seconds.
BATTERY
13001
RESET
SW:S1J41AH
(factory setting LED ON)
ERROR
LED
OFF
LED
ON
001
002
003
004
ERROR
001
002
003
004
When the screen is dis-
played, touch the button
for at least 3 seconds to
deactivate for reactivate op-
eration of the LED Worklights
during tool use;
a continuous beep will confirm
the setting.
ERROR
001
002
003
004

Publicidad

Tabla de contenido
loading

Tabla de contenido