Qlima P 432 Instrucciones De Uso página 94

E5 Overcurrent protection.
H8 Chassis is full of water.
Malfunction of ambient temperature sen-
F1
sor.
Malfunction of evaporator temperature
F2
sensor.
1. Refrigerant is leaking
F0
2. System is blocked
H3 Overload protection for compressor
E8 Overload malfunction
Outdoor tube temperature sensor is open/
F4
short-circuited.
Never attempt to disassemble or repair the device. Inexpert repairs invalidate the
guarantee and can endanger the users of the device.
M
GUARANTEE CONDITIONS
The air conditioner is supplied with a 24-month guarantee, commencing on the
date of purchase. All material and manufacturing defects will be repaired or
replaced free of charge within this period. The following rules apply:
1.
2.
3.
4.
5.
6.
7.
8.
4
94
We expressly refuse all further damage claims, including claims for collateral
damage.
Repairs to or replacement of components within the guarantee period will
not result in an extension of the guarantee.
The guarantee is invalidated if any modifications have been made, non
genuine parts are fitted or repairs are carried out by third parties.
Components subject to normal wear, such as the filter, are not covered by the
guarantee.
The guarantee is valid only when you present the original, dated purchase
invoice and if no modifications have been made.
The guarantee is invalid for damage caused by neglect or by actions that
deviate from those in this instruction booklet.
Transportation costs and the risks involved during the transportation of the
air conditioner or air conditioner components shall always be for the account
of the purchaser.
Damage caused by not using suitable Qlima filters is not covered by the gua-
rantee.
Disconnect power, and then turn on the
unit again after 10min. If "E5" still exits,
please contact professional person to
maintain the unit.
1. Pour out the water inside chassis.
2. If "H8" still exits, please contact profes-
sional person to maintain the unit.
Please contact professional person to deal
with it.
Please contact professional person to deal
with it.
1. Re-energize the unit after turning off
and pulling out the plug for 30min;
2. If there's still malfunction, please con-
tact after-sales service.
1.Check if the unit is under high-tempe-
rature and high-humidity environment; if
ambient temperature is too high, power
off the unit and then energize it for ope-
ration after the ambient temperature
drops to 35°C below.
2. Check if the evaporator and condenser
are blocked by some objects; if yes, take
away the objects, power off the unit and
then energize it for operation.
3. If the malfunction still occur, please con-
tact our after-sales service center.
Please contact after-sale service person to
deal with it.