Publicidad
G - OFFSET LAYOUT INSTALLATION
Loosen the screws of the 2 main clamps
II.
and the 2 set screws of the brackets
2 x M8
6
IV.
Remove the 2 main clamps, 4 screws,
nuts, washers and anti-rotation clips
from the initial position
initial position
01-85-943 | DOC-0018707 rev D | 03-2021
2 x M8
2 x M8
6
initial position
REASSEMBLY STEPS
I.
Lay the complete luminaire with all optical block
front faces touching the ground
Remove the shaft by rotating and pulling
III.
it in one direction
4
V.
Reassemble the 2 main clamps, 4 screws,
nuts, washers and anti-rotation clips to the
second position
second position
www.schreder.com
second position
9/12
Publicidad
