Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
5.
Find the green tether inside cylinder and attach it to the
heatsink using the screw and lock washer located in
the envelope attached to the tether. (Figure 13.)
Green
Ground
Wire
Figure 13.
6.
Install the LED Engine and trim assembly by inserting
the torsion springs into the spring receivers located
inside the housing. (Figure 14.)
Figure 14.
Cleaning
To Clean Trims:
1.
Gently wipe with soft, clean, dry lint-free cloth to
remove dust.
2.
Wipe with mild detergent solution on a soft, clean cloth
to remove fingerprints and stains.
3.
Rinse with clean water and dry with soft, clean, dry lint-
free cloth.
Wiring Diagrams and Instructions – LER*4B, LESQ*4B, LER*6B, & LESQ*
Screw
Lockwasher
Heatsink Screw
Boss
Torsion Spring
Reciever
Cooper Lighting Solutions
Electrical Connection
Make certain no bare wires are exposed outside of wire nut
connectors.
1.
Provide electrical service according to the "National
Electrical Code" or your local electrical code to the
cylinder housing assembly. Supply wire insulation must
be rated for at least 90°C.
2.
Connect supply lead wires to cylinder housing lead
wires (line, neutral and ground) in the fixture using
properly sized wire nuts. Be careful not to leave any
bare conductors outside of the wire nut connectors.
3.
Connect white to white, black to black, and green (from
electrical service) on the supply side to the green wire
in the cylinder housing assembly.
Wiring Diagrams
1. For D010TR Driver
BLACK (LINE)
BLACK (LINE)
TRIAC DIMMING
@120VAC OR 0-10V
WHITE
WHITE
@ 120 277VAC
(NEUTRAL)
(NEUTRAL)
DIMMING DRIVER
GRN
2. For D010TE Driver
BLACK (LINE)
BLACK (LINE)
TRAILING EDGE
DIMMING OR
WHITE
WHITE
0-10V DIMMING
(NEUTRAL)
DRIVER
(NEUTRAL)
GRN
IB520075ML
BLACK
BLUE
RED
LED
PURPLE
RED
GREY
MOUDLE WIRING
DIAGRAM
0-10V
DIMMING
OPTION (FIELD
INSTALLATION)
BLACK
BLACK
RED
LED
PURPLE
RED
GREY
MOUDLE WIRING
DIAGRAM
0-10V DIMMING
OPTION (FIELD
INSTALLATION)
Installation instructions
5
Publicidad
Tabla de contenido
