• Before filling the tank with water, remember to always disconnect the appliance at the socket.
• If the electric cable is damaged it must be replaced by the manufacturer or its Technical Assistance Service, or in any case
by a person with similar qualifications, in order to avoid any risk.
• Never let the live parts come into contact with water: this may cause a short circuit
• Unplug before any cleaning or maintenance operations.
• Do not immerse the appliance in water or other liquids.
• Unplug the appliance from the electricity supply immediately in the case of faults, defects or suspected defects after drop-
ping. Never operate the appliance if defective. Repairs can only be carried out by authorized assistance service centres.
The manufacturer disclaims all responsibility for any damage caused by incorrect repair work.
• Do not lift the appliance by grasping its water tank or its drip tray, but only by grasping its body.
• Choose a sufficiently well lit and clean environment, with an easily accessible electric socket.
• Avoid putting excessive quantities of water into the tank.
• The appliance is not to be used if it has been dropped, if there are visible sign of damage or if it is leaking. To prevent any
accident, all repairs, including the replacement of the power cord, must be carried out by an Authorised Service Centre or,
in any case, by qualified personnel.
• Do not use the appliance if the power cord appears to be damaged, with parts showing burns, etc; an Authorised Service
Centre must repair and replace the power cable; under penalty of the warranty being forfeited.
• Do not aim the jet of steam towards parts of the body; handle the steam spout with care: risk of scalding!
• Do not touch the metal parts of the pod holder when the machine is in operation; danger of burns.
• Be careful not to come into contact with the hot water while preparing coffee and when cleaning the pod holder or descal-
ing; danger of burns.
• Place the machine on a stable surface where it cannot be knocked over.
• Never use the machine without water because the pump will burn out.
• Never fill the water tank with hot or boiling water.
• Do not place the machine on very hot surfaces or near open flames in order to prevent damage to the body.
• The cable must not touch any hot parts of the machine.
• Do not use sparkling (carbonated) water.
• Use only pods bearing the E.S.E. standard mark.
• Never put anything other than pods inside the pod holder. They could cause serious damage to the appliance.
• Do not leave the machine at a room temperature below 0°C because the water remaining in the boiler could freeze and
cause damage.
• Never use the appliance outdoors.
• Do not expose the appliance to atmospheric agents (rain, sun ...).
• Before cleaning the appliance always unplug it and allow it cool down. Clean only with a non-abrasive cloth that has been
slightly dampened with water, adding a few drops of mild, non-aggressive detergent (never use solvents that damage
plastic).
sAVe These InsTrucTIOns fOr fuTure reference.
•
DescrIpTIOn Of The ApplIAnce
A - Machine body
B - Power cord + Plug
C - Steam dispensing cock
D - Water tank
E - Tank cover
F - Pods holder opening lever
G - Dispensing spout
H - Maxi-Cappuccino attachment and stylus for water and steam supply R - Boiler temperature indicator lamp
I - Cup-resting grill
J - Drip basin/used pods
Danger of damage originating from other causes
Warning of burns
Warning – material damage
K - Divider for used pods
L - Pod holder
M - Pod holder seat
N - Steam button
O - Steam on light
P - On/Off button
Q - Coffee dispensing button
S - On/Off light
11