Problem
The SmartGuard does not
move freely.
The SmartGuard does not re-
tract when the product is re-
moved away from the work
piece.
Transportation and storage
•
Safely attach the product during transportation to
prevent damage and accidents.
•
Remove the cutting blade before transportation or
storage of the product.
•
Keep the product in a locked area to prevent access
for children or persons that are not approved.
•
Keep the cutting blades in dry, frost free conditions.
•
Examine all new and used blades for transport and
storage damage before assembly.
•
Clean and maintain the product before storage.
Refer to
Maintenance schedule on page 26 .
Technical data
Cylinder displacement, cu.in./cm
Cylinder bore, in./mm
Travel length, in./mm
Idle speed, rpm
Fully opened throttle, no load, rpm
Power, hp/kW @rpm
Spark plug
Electrode gap, in./mm
Fuel tank capacity, US fl oz/liters
Recommended water pressure, PSI/bar
Weight
Power cutter without fuel and cutting blade 14in. (350mm), Ib/kg*
*Rescue carry strap, additional 0.9lb/0.4kg.
Power cutter without fuel and cutting blade 16in. (400mm), lb/kg
1429 - 001 - 16.04.2020
Cause
The moving parts of the SmartGuard
are clogged.
The springs of the SmartGuard does
not operate correctly.
Transportation, storage and disposal
Technical data
3
Possible solutions
Clean the moving parts.
Do a check of the springs. Clean the springs.
•
Remove the fuel from the fuel tank before long-term
storage.
Disposal
•
Obey the local recycling requirements and applicable
regulations.
•
Discard all chemicals, such as oil or fuel, at a service
center or at an applicable disposal location.
•
When the product is no longer in use, send it to a
Husqvarna dealer or discard it at a recycling
location.
K 970 III, K 970 III Res-
cue
5.7/93.6
2.2/56
1.5/38
2700
9300 (+/- 150)
6.5/4.8 @9000
NGK BPMR 7A
0.02/0.5
33.8/1
7-150/0.5-10
24.3/11.0
24.6/11.6
K 970 SmartGuard
5.7/93.6
2.2/56
1.5/38
2700
9300 (+/- 150)
6.5/4.8 @9000
NGK BPMR 7A
0.02/0.5
33.8/1
7-150/0.5-10
26.2/11.9
N/A
33