Brandson 303368 Manual De Usuario página 22

11 Inner pipe (inserted into the outer pipe when delivered (13))
12 Height adjustment nut
13 Outer pipe
14 Pedestal cover
15 Pedestal weight
16 Pedestal locking member
17 Pedestal - locking screw
18 Protective cage - locking screw
19 Protective cage - lock
5. Assembly
Take the fan out of the package and check the device as well as the scope of deliv-
ery mentioned in the table above. Please contact the supplier directly if any part is
missing or has been damaged.
1. To connect the base including the inner pipe (11) to the motor unit (8), first
screw the pedestal (14,15) to the outer pipe.
2. Take the pedestal weight (15), place the guard (14) on it, and connect the outer
pipe (13) to the pedestal.
3. Fix the outer pipe (13) to the pedestal (14,15) from below using the fastening
screw (16,17).
4. Connect the base unit to the motor unit (8,9).
5. To do this, connect the inner pipe (11) to the guide of the fan control (9) and
mount the inner pipe (11) using the adjusting screw (10).
6. Now place the rear protective cage (6) on the fan unit. Make sure that the
handle is facing up.
7. Tighten the rear protective cage firmly using the locking nut (5).
8. Then insert the rotor blade (4) onto the motor shaft (7) and fasten it using the
appropriate mounting screw (3). Make sure that the individual components are
properly mounted on the motor shaft (7) to avoid vibrations!
9. Mount the protection cage ring (2) to the front protective cage (1) and connect
it to the rear protection cage (6). The protection cage lock (19) is located at the
bottom of the two cages.
10. Fasten the lock (19) using the protection cage locking screw (18).
22
English