Extension Cords - Dremel 8100 Instrucciones De Funcionamiento Y Seguridad

1600A012FW_8100 1/30/17 12:27 PM Page 18
INSIDE. Preventive
performed by un au thorized personnel
may result in misplacing of internal wires
and components which could cause
serious hazard. We recom mend that all tool
service be performed by a Dremel Service
Center. SERVICE MEN: Disconnect tool and/or
charger from power source before servicing.
BATTERIES
Be alert for battery packs that are nearing
their end of life. If you notice decreased
tool performance or significantly shorter
running time between charges then it is time
to replace the battery pack. Failure to do so
can cause the tool to operate improperly or
damage the charger.
D.C. MOTORS
The motor in your tool has been engineered
for many hours of dependable service. To
maintain peak efficiency of the motor, we
adequate size conductors that is capable
of carrying the current necessary for your
tool must be used. This will prevent
excessive voltage drop, loss of power or
overheating. Grounded tools must use 3-wire
extension cords that have 3-prong plugs and
receptacles.
NOTE: The smaller the gauge number, the
higher the cord capacity.
Maintenance
Service
NO USER
SERVICEABLE PARTS
maintenance

Extension Cords

If an extension cord is
necessary, a cord with
recommend it be examined every six months.
Only a genuine Dremel replacement motor
specially designed for your tool should be
used.
Cleaning
To avoid accidents,
always disconnect the
tool and/or charger from the power supply
before cleaning. The tool may be cleaned
most effectively with com pressed dry air.
Always wear safety goggles when
cleaning tools with compressed air.
Ventilation openings and switch levers must
be kept clean and free of foreign matter. Do
not attempt to clean by inserting pointed
objects through opening.
Certain cleaning agents
and solvents damage
plastic parts. Some of these are: gasoline,
car bon tetrachloride, chlorinated cleaning
solvents, ammonia and household detergents
that contain ammonia.
RECOMMENDED SIZES OF ExTENSION CORDS
120 VOLT ALTERNATING CURRENT TOOLS
Cord Size in A.W.G.
Tool's
Ampere
Cord Length in Feet
Rating
25 50 100
18 16 16
18 16 14
3-6
18 16 14
6-8
16 16 14
8-10
14 12
10-12
12-16
18
Wire Sizes in mm 2
Cord Length in Meters
15 30 60 120
150
14 0.75 0.75 1.5 2.5
12 0.75 1.0 2.5 4.0
12 0.75 1.0 2.5 4.0
12 1.0 2.5 4.0
– – – – –
–
–