SEVERIN TO 2034 Instrucciones De Uso página 11

be removed.
∙ Do not position or operate the appliance
close to or underneath any wall-
cupboards or hanging objects such as
curtains or any infl ammable materials.
∙ During operation, the appliance must
be placed on a heat-resistant surface,
impervious to splashes and stains. Do
not position the appliance on or near hot
surfaces, open fl ames or infl ammable
vapours.
∙ Do not allow the power cord to touch any
hot parts of the appliance.
∙ Do not let the power cord hang free.
∙ Always switch off and remove the plug
from the wall socket
- after use, as well as
- in cases of malfunction, and
- during cleaning.
∙ When removing the plug from the wall
socket, never pull on the power cord;
always grip the plug itself.
∙ No responsibility is accepted if damage
results from improper use, or if these
instructions are not complied with.
∙ This appliance is intended for domestic or
similar applications, such as
- in shops, offi ces and other similar
working environments,
- in agricultural working environments,
- by customers in hotels, motels etc. and
similar establishments,
- in bed-and breakfast type environments.
Temperature control
With the temperature control knob, the
temperature can be set to the desired level.
4-position switch settings
l No setting selected
Upper heat
Upper and lower heat
Lower heat
The heating elements will only come on once
the timer is activated.
Timer
The timer can be used for either selecting a
certain cooking time (up to 60 minutes).
To turn the unit off, turn the switch to position
0. To pre-programme the cooking time, turn
the switch clockwise to the desired time.
To set a time of less than 10 minutes, turn the
timer to a somewhat higher setting fi rst and
then slowly turn it back to the desired time
setting. After the pre-programmed time has
elapsed, an acoustic signal indicates that the
heating elements are switched off. To switch
off the entire appliance, the heating elements
must be switched off as well.
Indicator lamp
The indicator lamp lights up when the
appliance is switched on. It goes out once
the pre-programmed time has elapsed, or if
the switch is turned back to position 0.
Start up
∙ Clean the appliance (see General care
and cleaning) and remove any packing
materials completely.
∙ Before using the appliance for the fi rst
time, let it heat up for 15 minutes with
both heating elements on. When the
appliance is fi rst switched on, a slight
smell may be emitted. This is normal and
will only last for a very short time. Ensure
suffi cient ventilation.
11