Craftmade BC52 Instrucciones De Instalación página 3

Preparation
Important: When using an existing outlet box, be sure the box is securely attached
to the building structure and can support the full weight of the fan. Failure to do
so can result in serious injury or death.
1
Step 1
Turn off circuit breakers and wall switch to the fan
supply line leads.
Warning: Failure to disconnect power supply prior to
installation may result in serious injury or death.To reduce
the risk of shock, this fan must be installed with an
isolating wall control/switch.
2
Step 2
Determine mounting method to use.
A. Downrod Mount
B. Angle Mount
Craftmade Part #45AD (see dealer)
IMPORTANT: If using the angle mount
method, check to make sure the ceiling angle
is not steeper than 35°. Angles greater than
35° will require a 45° angle adapter.
3
Check to make sure blades are at
least 30" from any obstruction.
Check downrod length to
ensure blades are at least
7' above the floor.
Downrod Installation
(Normal Ceilings)
Downrod Installation
(Vaulted Ceilings)
Step 3
0.75m
84"
(2.1m)
Min.
4
Prior to securing mounting bracket, screw "J" hook (S9) into ceiling outlet
box as a secondary support means. Secure mounting bracket (#1) to the
outlet box (A) by tightening bracket screws & washers (S3) as shown. If
not mounting to an outlet box, use wood screws (S1) and washers (S3) and
mount securely to ceiling beam. Be sure at this point to insert canopy
screws (S2) in bracket.
NOTE: J Hook installation is a Canadian requirement only.
"J" Hook (S9)
Ceiling
Bracket Screws
& Washers (S3)
Wood Screws (S1)
5
Step 5
Locate downrod assembly
(#2). Loosen ball screw on
black hanging ball to free
lock pin. Black hanging
ball will slide down.
Remove ground screw and
green ground wire.
Remove hanging ball from
30"
downrod and save all
parts. Insert fan wires
Min.
through downrod. Screw
downrod into top of fan
motor housing, being
careful that wires are
pulled through.
Step 4
NOTE: Do not mount directly to sheet rock or ceiling tile.
Support Beam
Outlet Box (A)
OUTLET BOX
Mounting Bracket (1)
Wood Screws (S1)
Canopy Screws (S2)
Lock Pin
Downrod
Assembly
(#2)
Fan Motor Housing
Green Ground
Wire
Ball Screw
Hanging Ball
Downrod