Craftmade BC52 Instrucciones De Instalación página 4

6
Position downrod so the hole in the downrod aligns with the hole in the
coupling on the motor. Insert safety bolt (S7) through coupling and downrod
and attach nut. Tighten firmly. Tighten set screw "A" against downrod. For
BC & OPXL Series place flange cover (4) over downrod assembly until it
covers flange. Place canopy (3) over downrod (2). Replace hanging ball,
insert hanging pin through downrod and tighten set screw "C" in hanging
ball into downrod.
NOTE: Flange cover will not work with supplied 2 1/2 inch downrod. Flange cover is
decorative and will not affect the operation of the fan.
Threaded
Set Screw Hole
Ground
Hanging
Wire
Pin
Ball
Hanging Screw
Ball
Safety Bolt
and Nut (S7)
WARNING: Failure to completely tighten downrod as described in steps
5 & 6 above could result in the fan loosening and possibly falling.
Step 6
Set Screw (C)
Downrod (2)
Canopy (3)
Flange Cover (#4)
(if included in parts list)
Set Screw (A)
Motor Housing (5)
7
For added security, attach safety cable from fan unit to "J" hook (S9) in
outlet box. Secure by looping zip tie (S10) through safety cable and "J"
hook. Tighten zip tie securely. Lift fan onto the mounting bracket (#1).
Turn housing until hanging ball seats itself into ball socket (listen for click).
OUTLET BOX
Green Ground Wire
NOTE: Parts furnished will allow
"J" Hook (S9)
you to install your fan at up to a 35°
angle. Angles greater than 35° will
require a 45° angle adapter (see
dealer). NOTE: J Hook installation
is a Canadian requirement only.
WARNING: To reduce the risk of fire, electric shock or personal injury, mount
so outlet box marked "acceptable for fan support" and use mounting screws
provided with the outlet box. Most outlet boxes commonly used for the support
of lighting fixtures are not acceptable for fan support and may need to be replaced.
Consult a qualified electrician if in doubt.
Step 7
Support Beam
"J" Hook (S9)
Outlet Box (A)
Ceiling
Mounting Bracket (#1)
Zip Tie (S10)
Safety Cable