Led Light - Black and Decker LI3100 Manual De Instrucciones

ADDITIONAL SAFETY INSTRUCTIONS
FOR BATTERIES AND CHARGERS
Batteries
Never attempt to open for any reason.
Do not expose the battery to water.
Do not expose the battery to heat.
Do not store in locations where the temperature may
exceed 40 °C.
Charge only at ambient temperatures between 10 °C and
40 °C.
Charge only using the charger provided with the
appliance/tool.
When disposing of batteries, follow the instructions given
in the section "Protecting the environment".
Do not damage/deform the battery pack either by puncture
or impact, as this may create a risk of injury and fire.
Do not charge damaged batteries.
Under extreme conditions, battery leakage may occur.
When you notice liquid on the batteries carefully wipe the
liquid off using a cloth. Avoid skin contact.
In case of skin or eye contact, follow the instructions below.
Warning! The battery fluid may cause personal injury or
damage to property. In case of skin contact, immediately rinse
with water. If redness, pain or irritation occurs seek medical
attention. In case of eye contact, rinse immediately with clean
water and seek medical attention.
Chargers
Your charger has been designed for a specific voltage.
Always check that the mains voltage corresponds to the
voltage on the rating plate.
Warning! Never attempt to replace the charger unit with a
regular mains plug.
Use your Black & Decker charger only to charge the
battery in the tool with which it was supplied. Other
batteries could burst, causing personal injury and damage.
Never attempt to charge non-rechargeable batteries.
If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard.
Have defective cords replaced immediately.
Do not expose the charger to water.
Do not open the charger.
Do not probe the charger.
The appliance/tool/battery must be placed in a well
ventilated area when charging.
The charger is intended for indoor use only.
Read the instruction manual before use.
Fail safe isolating transformer. The mains supply is
electrically separated from the transformer output.
The charger automatically shuts off if the ambient
temperature becomes too high. As a consequence
the charger will be inoperable. The unit must be
disconnected from the mains supply and taken to an
authorised service centre for repair.
FEATURES
1. On/off switch
2. Forward/reverse slider
3. Bit holder

4. LED light

Fig. A
5. Charger
6. Charger plug
ASSEMBLY
Fitting and removing a drill bit or a screwdriver bit
(fig. B)
This tool uses screwdriver bits and drill bits with a 6.35 mm
(1/4") hexagonal shank.
To fit a bit, insert the bit shaft into the bit holder (3).
To remove a bit, pull the bit shaft out of the bit holder (3).
USE
Warning! Let the tool work at its own pace. Do not
overload.
Before first use, the battery must be charged for at least
9 hours.
Charging the battery (fig. C)
Insert the charger plug (6) into the charger connector (7).
Plug in the charger (5).
Leave the tool connected to the charger for 12 hours.
The charger may hum and become warm while charging; this
is normal and does not indicate a problem.
Warning! Do not charge the battery at ambient
temperatures below 10 °C or above 40 °C.
Selecting the direction of rotation (fig. D)
For drilling and for tightening screws, use forward rotation.
For loosening screws or removing a jammed drill bit,
use reverse rotation.
To select forward rotation, push the forward/reverse slider
(2) to the forward position.
To select reverse rotation, push the forward/reverse slider
(2) to the rearward position.
To lock the tool, set the forward/reverse slider into the
centre position.
15
ENGLISH