Leak Check Preparation - Weber Summit 420 Guia Del Propietario

leaK CheCK preparation

Check that all burner Valves are off
Valves are shipped in the OFF position, but you should check to be sure that they are
turned off . Check by pushing in and turning clockwise . If they do not turn, they are off . If
they do turn continue turning them clockwise until they stop, then they are off .
m warninG: the gas connections of your summit
have been factory tested. we do however recommend that
you leak check all gas connections before operating your
summit gas grill.
®
remove Control panel
Parts required: Phillips screwdriver and a towel .
A) Remove the burner control knobs (1) .
B) Open both doors and place a towel on top of the doors . This will protect the control
panel and tops of the doors from getting scratched on the next step .
C) Remove the screws from the underside of the control panel with a Phillips
screwdriver (2) .
D) Tilt the conrol panel forward and lift up and away from the grill (3) (For Summit
models with LED features: Be careful not to break or disconnect the wires for the
control panel LED's) .
E) Place the control panel on the towel covering the door assemblies (4) .
10
GAS INSTRUcTIoNS
gas grill
®
®
◆
the grill illustrated
may have slight
differences than the
model purchased.
1
2
3
4