Circuit Breaker Instructions - Weston BUTCHER Serie Manual De Instrucciones

CIRCUIT BREAKER INSTRUCTIONS

This Grinder is equipped with a Circuit
Breaker as a safety precaution. If the Grinder
stops running follow these steps to remedy:
1. Turn the Grinder to the "Off" position.
2. Check the Grinder to see if there is a jam in
the Grinder Head. If there is, the jam needs
to be cleared of the obstruction as outlined in
"Grinding Tips".
2. Press the Circuit Breaker Reset Button
(FIGURE 13).
3. Turn the Grinder back on and resume
grinding.
4. If the Grinder still does not turn on, check that the electrical wall outlet is
properly working. Plug in another appliance to see if that appliance works from
the wall outlet. Check that the household circuit breaker has not been tripped. If
none of the above steps remedy the situation, or if the Circuit Breaker repeatedly
shuts off the Grinder contact a customer service for further assistance.
WARNING! DO NOT continue to use the Grinder if the Circuit Breaker trips
repeatedly. Continued use may cause permanent damage to the Grinder and
will void the warranty.
PLEASE NOTE:
transmission. This causes the Grinder to operate at a higher volume and
temperature than other Grinders. This is normal and will not affect the
Grinder's performance.
GRINDING TIPS
. DO NOT over-tighten the Front Ring Nut. It should be firmly tight.
. Make sure the Grinding Knife blades lay flat on the Grinder Plate.
. DO NOT operate the Grinder without meat in the Head. Running the
Grinder while dry could damage the Head and Auger.
. ALWAYS lubricate the Head, Grinding Plate and Grinding Knife with a food-
grade silicone spray after cleaning.
. If the Grinder Plate becomes jammed/clogged during operation, follow these
steps to restore normal output.
. Turn the Grinder "OFF" and disconnect the Power Cord from the electrical outlet.
. Remove the Front Ring Nut and Grinding Plate.
. Thoroughly clean the Grinding Plate. Make sure all of the holes are clear.
. Re-install the Grinding Plate and Front Ring Nut.
. Re-connect the Grinder to the electrical outlet.
Continue with grinding.
. Repeat as necessary.
This Grinder features an all hardened steel gear
FIGURE 13
Circuit Breaker
Reset Button
15