Resetting The Device To Factory Settings; Cleaning And Storage; Disposal; Technical Data - Beurer WL 70 Instrucciones De Uso

2. The light turns on and 2 0 l i g h t appears in the
display; immediately afterwards, use the +/- buttons
on the side to set the desired brightness of the light
(can be selected between 1-20). Use the Light button
to confirm. 10 sun set appears in the display.
3. Use the +/- buttons on the side to select the desired
duration of the sunset (2, 5, 10, 15, 20, 30, 45 or
60 minutes), then wait for 5 seconds. The sunset
function is then activated automatically and a small
icon appears in the display. The light will now go
out automatically once the configured duration of the
sunset has elapsed.
Note
Sunset with music
The device can also be used to simulate a sunset while
you listen to music. In the process, the light slowly
turns darker after a set duration. The music is switched
off automatically after the set duration has elapsed.
To start a sunset with music on the device, proceed
as follows:
1. When the device is switched on, select the desired
music source (radio (FM) or AUX).
2. Perform the subsequent steps as in "8.7.2 Sunset
function".

8.7 Resetting the device to factory settings

If you wish to reset all settings on the wake-up light to
the factory settings, proceed as follows:
1. Remove the mains adapter of the wake-up light from
the socket.
2. Press and hold both the Menu/Set button and the Light
button on the device, which is now switched off, and
reinsert the mains adapter of the wake-up light into
the socket. Keep pressing the buttons about 10 sec..
3. The device has now been reset to the factory settings.

9. Cleaning and storage

• Clean the device with a dry cloth.
• Do not use any abrasive cleaning products.
• Ensure that no water enters the device. If this should
happen, reuse the device only when it has fully dried
out.
• Never immerse the device or mains part plug in water
or other liquids.
• Protect the device from impacts, humidity, dust,
chemicals, marked temperature fluctuations and nearby
sources of heat (ovens, heaters).

10. Disposal

For environmental reasons, do not dispose of the device
in the household waste at the end of its useful life.
Dispose of the device at a suitable local collection
or recycling point. Observe the local regulations
for material disposal. Dispose of the device in
accordance with EC Directive – WEEE (Waste
Electrical and Electronic Equipment). If you have any
questions, please contact the local authorities responsible
for waste disposal.

11. Technical data

Illuminance
Light
Light levels
Wake-up light
function
Sunrise function
Snooze duration
Sunset function
Good night
function
(sleep radio)
LCD backlighting
Time
Alarm
Button tone
AUX
Radio
Speaker
Mains part
voltage supply
Mains part
protection class
Subject to technical changes.
14
Max. approx. 2500 lux
(at distance of 15 cm)
LED technology (white LED
service life: > 50,000 hours;
coloured LED: > 20,000 hours)
20 light levels with simulation
of dawn
Off, 2, 5, 10, 15, 20, 30, 45,
60 minutes prior to alarm
Maximum light intensity up to
alarm: Light level 5, 10, 15, 20
1, 2, 5, 10, 20, 30 minutes
2, 5, 10, 15, 20, 30, 45, 60 minutes
2, 5, 10, 15, 20, 30, 45, 60 minutes
Off, 1, 2, 3
Toggle 12h/24h mode, 15 minute
buffer in event of power failure
3 alarm times (Off, On, Day)
Alarm tone, 4 sounds, radio
Off, On
Line-in, 3.5 mm jack plug
Frequency range VHF 87.5-108
MHz, 10 memory spaces
2 Watt
Input: 110-240 V, AC, 50/60 Hz,
0.5 A
Output: 9 V, DC, 1500 mA
Protection class II