Truper GEN-80X Manual De Instrucciones página 10

Ocultar thumbs Ver también para GEN-80X:
Tabla de contenido

Publicidad

• Double-check all the devices are working correctly
before connecting to the generator. In case a device starts
operating in an abnormal or awkward way or it stops
without any reason, immediately shut off the thermal
overload protector and the motor switch. Then, disconnect
the device and check the cause it is malfunctioning.
• After the loads have been connected to the generator,
inspect the connections are set right. Otherwise, to err
in the connections will cause damage to the generator. It
could also catch fire.
Fig. 8
3. Set the thermal overload protector in the ON position
(Figure 9).
NOTICE
Overload in the current will automatically shut off
the switch. Reduce the load and let the generator to stop a
couple of minutes. Then, turn on the generator.
Fig. 9
NOTICE
If the battery will not be used for a long period of
time (should not exceed three months), recharge it 3 to 5 hours
with 2A - 5A current before using it again.
To shut off the motor
1. Set the overload thermal
protector in the OFF position.
2. Close the fuel tap.
8
3. Shut off the motor, turn the
switch key to the OFF position.
4. Remove all the loads
NOTICE
shut off the generator and directly
set the motor switch in the OFF
position.
Operating in high altitude
When the generator is in high altitude, the fuel-air mix in a
standard carburetor will be fuel-rich. Performance will diminish
and fuel consumption will increase.
The performance during a high altitude opertion may improve
if the carburetor is adjusted and if the head pin is set. Your
generator is set to operate at higher altitudes than 6 000 ft
above sea level, if you notice that your generator does not
operate efficiently, allow a Truper authorized service center to
perform the corresponding modifications to the carburetor.
Even tough carburetor injection is adequate, power in the motor
will decrease 3,5% approximately with each 1 000 ft increment
above 6 890 ft above sea level. Regarding altitude, change
in power will be higher if any carburetor adjustment is made.
that is inadequate to that at which the carburetor is adjusted,
this could result in poor performance, overheating, and serious
engine damage caused by an excessive air-fuel mixture, check
according to the chart shown below.
CLOSED
OPEN
If needing to urgently
WARNING
If the generator is operating at an altitude

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

15345

Tabla de contenido