Tabla de contenido
Publicidad
Regular maintenance and adjustment is needed to get
adequate working conditions in the generator. Service and
check-up should be made according to the table shown
below.
NOTICE
Shut off the motor before any type of maintenance
work. Before you start doing maintenance double-check
the generator will not unexpectedly start running.
Oil change
To assure full and quick drainage, remove oil contents while
the motor is still warm.
1. Unscrew and remove the oil-
measuring rod.
2.
Using
counterclockwise
direction unscrew oil drain cap
and drain oil.
3. When finishing draining reset
the drain cap.
4. Pour motor oil (SAE-10W30) up
to the rod upper level.
5. Set rod into the filling orifice
and screw back.
Select motor oil with viscosity
adequate for the region average
temperature.
WARNING
®
Truper
original spare parts. Using non-original parts could
damage the generator.
Maintenance Agenda
We recommend doing maintenance in the generator each
month or hours of operation whichever comes first in the
Periodic Maintenance Table.
WARNING
when in contact with skin for long periods of time. However,
this is almost impossible to happen if using oil in minimal
daily proportions. Washing hands with soap and water is
recommended after working with oil.
NOTICE
Please dispose off oil in an environment friendly
way. We suggest to pour oil in a sealed container and to take it
to your local gas station. Do not dispose with household waste
or pour in the ground.
Oil filter
DRAIN
PLUG
A dirty oil filter will block air entering the carburetor. Clean
regularly to prevent carburetor failure. (Figure 10).
LEVEL
MAX.
1. Remove the oil filter cap. Remove screw and air filter
cover.
2. Wash cartridge with a household detergent and water
solution. Rinse or clean with low ignition degree or non-
flammable solvents. Dry cartridge completely.
For maintenance or repairs use only
Used motor oil is a cause of skin cancer
9
Publicidad
Tabla de contenido
