Troubleshooting - ERATOS VCF4G Manual De Instalación, Uso Y Mantenimiento

5. TROUBLESHOOTING

In some cases working failures can be produced by simple causes that the user can solve.
Before asking for the technician assistance, we recommend that you carry out the following verifications:
Problem
The well is too cold.
The well is too hot.
The thermostat blinks showing
the "OFF" signal
equipment does not work.
The light does not work
The equipment is plugged in but
it does not work.
If you continue with difficulties to solve a problem, please contact the supplier for assistance.
6. RECYCLING
At the end of its working life, the equipment must be disconnected from the mains to proceed to the
disassembling of its components. The equipment must be disassembled respecting the current regulations,
especially in what the coolant gas is concerned.
Pay close attention to avoid risks associated to the shape and weight of each component.
The different components (electric pieces, rubber tubes, cable guides, etc.) have been selected with the
objective of obtaining the best results in terms of the environment according to current laws.
7. WARRANTY
Eratos warranty covers all manufacturing defect or hidden fault of the equipment during a complete year. It
consists of the substitution of the faulty piece/s only if it is not due to improper use, inadequate installation or
cleaning different from what is stated in the manual.
Probable cause
Programmed temperature is very
low.
The digital thermostat does not
work correctly.
The food has not been cooled
before its placement in the unit.
The programmed temperature is
too high.
The condenser is obstructed with
dust and/or fluffs.
The digital thermostat does not
work properly.
The equipment does not cool
enough.
The equipment is on "wait" mode.
and the
The light strip is faulty.
The switch is off.
The equipment is off.
The digital thermostat does not
work correctly.
The condenser overheats.
The refrigerating system does not
work correctly.
Solution
Adjust
temperature value
Contact your supplier.
Introduce exclusively cooled or refrigerated
products.
Adjust the thermostat to a lower
temperature level.
Clean the condenser.
Contact the supplier.
Contact the supplier.
Press and hold the "On" button during three
seconds. The equipment will go back to its
normal state.
Substitute the light strip.
Turn the switch on.
Turn the equipment on.
Contact the supplier.
Contact the supplier.
Contact the supplier.
14
the thermostat to a
EN
higher