Product Safety Information; Product Specifications - Ingersoll Rand 2906P Serie 2906P1 Especificaciones Del Producto

Product Safety Information

Intended Use:
These Air Impact Wrenches are designed to remove and install threaded fasteners.
For additional information refer to Product Safety Information Manual Form 04580916.
Manuals can be downloaded from ingersollrandproducts.com.
Power Management System
For models that include a power management system, the system allows operator reduction of
maximum output power in either the forward or the reverse direction.
For reduced power in the forward direction and full power in the reverse direction, push the
reverse valve inward on the right side of the tool and rotate the reverse valve until the notch on
the right side aligns with the desired number on the right side. This provides reduced power in
forward but full power in reverse when the reverse valve is pushed in the opposite direction. (See
TPD1248 on page 2.) For reduced power in the reverse direction and full power in the forward
direction, push the reverse valve inward on the left side of the tool and rotate the reverse valve
until the notch on the left side aligns with the desired number on the left side. This provides full
power in forward but reduced power in reverse when the reverse valve is pushed the opposite
direction. (See TPD1249 on page 2.) For full power in both directions, rotate the Reverse Valve
until the notch on each end of the Reverse Valve aligns with 5 on each side of the housing.
The power level indicators (See TPD1248 and TPD1249) are for reference and DO NOT indicate
a specific power. The power output can be further reduced in forward or reverse by using the
variable throttle.

Product Specifications

Models Style
2906P1
Pistol
2906P1-EU
2906P1-2-EU Pistol
Models
† Pressure (L
2906P1
2906P1-EU
2906P1-2-EU
† K = 3dB measurement uncertainty
pA
‡ K = 3dB measurement uncertainty
wA
*K= Vibration measurement uncertainty
Sound and vibration values were measured in compliance with internationally recognized
test standards. The exposure to the user in a specific tool application may vary from these
results. Therefore, on site measurements should be used to determine the hazard level in
that specific application.
04584801_ed5
Drive
Impacts
per min.
Type Size
Square 1/2"
Square 2"
1/2"
extended
Sound Level dB(A)
(ISO15744)
) ‡ Power (L
p
80.7 91.7
80.7 91.7
WARNING
Recommended Torque Range
Forward
ft-lb (Nm)
1,200 40-350 (54.2-475) 40-350 (54.2-475)
1,200 40-350 (54.2-475) 40-350 (54.2-475)
Vibration (m/s²)
) Level
w
7.6
7.2
EN
Reverse
ft-lb (Nm)
(ISO28927)
*K
0.9
0.8
EN-1