Operating Instructions; Dc Voltage Measurements - Multimetrix DMM 240 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

•)))
Continuity
Diode test
Battery status
-9
n
nano (10
) capacity
-6
µ
micro (10
) (amps)
-3
m
milli (10
) (volts, amps)
A
Amps
3
k
kilo (10
) (ohms)
6
M
mega (10
) (ohms)
Ω Ω Ω Ω
Ohms
° F
Degrees Fahrenheit
° C
Degrees Celsius
-
Negative polarity

3. OPERATING INSTRUCTIONS

Risk of electrocution. High-voltage circuits, both AC and DC,
are very dangerous and should be measured with great care.
1. Always turn the function switch to the OFF position when the
multimeter is not in use.
2. If "OL" appears on screen during a measurement, the value
exceeds the range you have selected. Choose a higher range.

3.1 DC voltage measurements

Do not measure DC voltages if a motor on the circuit is being
switched ON or OFF. Voltage surges may occur and damage
the multimeter.
1. Set the function switch to the VDC position.
2. Insert the black test lead banana plug into the
negative COM terminal.
Insert the red test lead banana plug into the
positive + terminal.
3. Apply the test probes to the points of the circuit
to be tested.
4. The voltage measured is displayed on screen.
22
Chapter II
Hz
Hertz (frequency)
V
Volts
%
Duty Cycle
REL
Relative Measurement
AUTO
Autoranging
HOLD
Display hold
MIN
Minimum
MAX
Maximum
AC
Alternating current
DC
Direct current
n
Capacity expressed in
-9
nanofarads (10
)
F
Farad capacity
Bargraph
DMM240

Publicidad

Tabla de contenido
loading

Tabla de contenido