Light Kit Assembly; Testing Your Fan - Craftmade Twist N Click TCE52 Manual Del Usuario

9. Light Kit Assembly.

Remove socket covers from sockets on light kit
fitter. Attach glass shades to sockets, securing
with socket covers.
Do NOT overtighten socket covers as glass may
crack or break.
Install four 6.5 watt max. medium base LED
bulbs (included).
IMPORTANT: When you need to replace bulbs,
please allow bulb(s) and glass shades(s) to
cool down before touching them.

10. Testing Your Fan.

It is recommended that you test fan before
finalizing installation. Restore power from circuit
box and light switch (if applicable). Test fan speeds
with pull chain located on switch housing. Start at
the OFF position (no blade movement). First pull
will set the fan to HI. Second pull will set the fan to
MEDIUM. Third pull will set the fan to LOW. Fourth
pull will again set the fan to the OFF setting. Test
light with the pull chain in the middle. (diagram 1.)
If fan does not function, please refer to
"Troubleshooting" section to solve any issues
before contacting Customer Service.
Turn fan completely off before moving the reverse
switch. Set reverse switch to recirculate air
depending on the season:
- LEFT position in summer (diagram 2)
- RIGHT position in winter (diagram 3)
A ceiling fan will allow you to raise your thermostat
setting in summer and lower your thermostat
setting in winter without feeling a difference in
your comfort.
Important: Reverse switch must be set either
completely LEFT or completely RIGHT for fan to
function. If the reverse switch is set in the middle
position (diagram 4), fan will not operate.
Attach pull chain extension(s) supplied or custom
pull chain extension (sold separately) to the end(s)
of the pull chain(s).
light kit
fitter
socket cover
reverse
switch
diagram 1
diagram 2
page 7
socket
bulb
pull chain
extensions
diagram 4
diagram 3