Operation - Homelite UT09520 Manual Del Operador

WARNING:
Do not allow familiarity with product to make you care-
less. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1, along with hearing protection.
Failure to do so could result in objects being thrown into
your eyes and other possible serious injuries.
APPLICATIONS
You may use this product for the purposes listed below:
 Clearing leaves and other debris from your lawn
 Keeping decks and driveways free from grass clippings,
leaves, pine needles, and other debris
FUELING AND REFUELING
FUEL MIXTURE
This product is powered by a 2-cycle engine and requires
pre-mixing gasoline and 2-cycle lubricant. Pre-mix unleaded
gasoline and 2-cycle engine lubricant in a clean 1 gallon
container approved for gasoline.
Recommended fuel: This engine is certified to operate on
unleaded gasoline intended for automotive use.
Mix Homelite Premium Exact Mix lubricant with gasoline
according to the instructions on the package. If Premium
Exact Mix lubricant is not available, use a high quality syn-
thetic 2-cycle engine lubricant, mixed at 2.6 oz. per gallon
(US). We recommend you use ONLY Homelite lubricant in
your product.
Do not use automotive lubricant or 2-cycle outboard lubri-
cant.
NOTE: Premium Exact Mix fuel mix will stay fresh up to
30 days. DO NOT mix quantities larger than usable in a 30
day period.
PREMIUM EXACT MIX (50:1)
GASOLINE
1 gallon (US)
1 liter

OPERATION

FILLING THE TANK
Gasoline and its vapors are highly flammable and ex-
plosive. To prevent serious personal injury and property
damage, handle it with care. Keep away from ignition
sources and open flames, handle outdoors only, do not
smoke while mixing gasoline and lubricant together; and
wipe up spills immediately.
 Clean the surface around the fuel cap to prevent con-
 Loosen the fuel cap slowly by turning counterclockwise.
 Pour the fuel mixture carefully into the tank.
 Clean and inspect the fuel cap gasket before replacing
 Replace the fuel cap and tighten it by turning it clockwise.
 Wipe spilled fuel from the product.
 Move at least 30 ft. away from refueling area before start-
NOTE: It is normal for smoke to be emitted from a new
engine during first use.
Always shut off engine before fueling. Never add fuel to a
machine with a running or hot engine. Move at least 30 ft.
from refueling site before starting engine. Do not smoke
and stay away from open flames and sparks. Unsafe
handling of fuel could result in seri ous personal injury.
OXYGENATED FUELS
DO NOT USE E85 FUEL. IT WILL VOID YOUR WARRANTY.
NOTE: Fuel system damage or performance problems re-
sulting from the use of an oxygenated fuel containing more
than the percentages of oxygenates stated previously are
not covered under warranty.
Ethanol. Gasoline containing up to 10% ethanol by vol-
ume (commonly referred to as E10) or 15% ethanol by
volume (commonly referred to as E15) are acceptable.
Do not use E85 fuel.
LUBRICANT
STARTING AND STOPPING
2.6 oz.
See Figure 3.
20cc (20 ml)
Blower should be on a flat, bare surface for starting.
 Slowly press the primer bulb 10 times.
Page 8 — English
WARNING:
tamination.
the fuel cap.
ing the product.
WARNING:
NOTE: After the 10th press, fuel should be visible in the
primer bulb. If it is not, continue to press the primer until
you see fuel in the bulb.