Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
24 • ENGLISH
c. Disconnect the plug from the power source and/or
the battery pack from the power tool before
making any adjustments, changing accessories,
or storing power tools. Such preventive safety measures
reduce the risk of starting the power tool accidentally.
d. Store idle power tools out of the reach of children
and do not allow persons unfamiliar with the power
tool or these instructions to operate the power
tool. Power tools are dangerous in the hands
of untrained users.
e. Maintain power tools. Check for misalignment
or binding of moving parts, breakage of parts and
any other condition that may affect the power
tools operation. If damaged, have the power tool
repaired before use. Many accidents are caused by
poorly maintained power tools.
f.
Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges are
less likely to bind and are easier to control.
g. Use the power tool, accessories and tool bits etc.
in accordance with these instructions, taking into
account the working conditions and the work
to be performed. Use of the power tool for operations
different from those intended could result in a
hazardous situation.
5. Battery tool use and care
a. Recharge only with the charger specified
by the manufacturer. A charger that is suitable
for one type of battery pack may create a risk of fire.
b. Use power tools only with specifically designated
battery packs. Use of any other battery packs may
create a risk of injury and fire.
c. When battery pack is not in use, keep it away from
other metal objects like paper clips, coins, keys,
nails, screws or other small metal objects that
can make a connection from one terminal to
another. Shorting the battery terminals together may
cause burns or a fire.
d. Under abusive conditions, liquid may be ejected
from the battery, avoid contact. If contact
accidentally occurs, flush with water. If liquid
contacts eyes, additionally seek medical help.
Liquid ejected from the battery may cause irritation
or burns.
6. Service
a. Have your power tool serviced by a qualified
repair person using only identical replacement
parts. This will ensure that the safety of the power
tool is maintained.
7. Electrical safety
Your tool is double insulated; therefore no earth
wire is required. Always check that the main
voltage corresponds to the voltage on the rating
plate.
Warning! If the power cord is damaged, it must
be replaced by the manufacturer, authorized
STANLEY Service Center or an equally qualified
person in order to avoid damage or injury. If the
power cord is replaced by an equally qualified
person, but not authorized by STANLEY, the
warranty will not be valid.
8. Labels on tool
The label on your tool may include the following
symbols:
W ........
Read
Instructions
min .....
Manual
Use Eye
Protection
Use Ear
Protection
n
.......
0
V ........
Volts
A ........
Amperes
Hz .......
Hertz
Labels on charger and battery pack
In addition to the pictographs used in this manual,
the labels on the charger and the battery pack may show
the following pictographs:
See Technical
Data for charging
time
Battery charging
Battery charged
Battery defective
Hot/Cold pack
delay
Do not probe
with conductive
objects
Do not charge
damaged battery
packs
Watts
....
minutes
....
.....
Alternating
Current
.../min..
.....
Direct
Current
No-Load
....
Speed
...... Class II
Construction
Do not expose
to water
Have defective
cords replaced
immediately
Charge only
between 4 ˚C
and 40 ˚C
Only for indoor
use
Discard the
battery pack with
due care for the
environment
Batter pack
Do not
incinerate the
battery pack
Earthing
Terminal
Safety Alert
Symbol
Revolutions
or Recipro-
cation per
minute
The charger
is intended
for indoor
use only.
Publicidad
Tabla de contenido
