Husqvarna 330i Manual Del Usuario página 25

2. Wrap your fingers and thumbs around the handles
and hold the product tight.
3. Apply full power and tilt your left wrist against the
front hand guard to engage the chain brake. The
saw chain must stop immediately.
WARNING: Do not let go of the front handle!
To do a check of the power trigger lockout
1. Make sure that the power trigger and power trigger
lockout move freely and that the return spring works
correctly.
2. Press down the power trigger lockout and make sure
that it goes back to its initial position when you
release it.
958 - 010 - 24.04.2020
3. Make sure that the power trigger is locked at the idle
position when the power trigger lockout is released.
4. Start the product and apply full power.
5. Release the power trigger and make sure that the
saw chain stops and stays stationary. If the saw
chain rotates when the power trigger is in the idle
position, turn to your servicing dealer.
To do a check of the chain catcher
1. Make sure that there is no damage on the chain
catcher.
2. Make sure that the chain catcher is stable and
attached to the body of the product.
To do a check of the keypad
1. Start the product. See
16
2. Press the start/stop button again.
3. Make sure that the product stops when you press
and hold the button. The green LED will go off.
To do a check of the battery and the
battery compartment
1. Clean the battery and the battery compartment with
a soft brush.
To start the product on page
25